EtherChannel (ENCOR, CCNP Quiz) Please enter your email: Which mode will configure LACP in a way that it will initiate the EtherChannel negotiation? Active Passive Desirable Auto Which of these is a link aggregation protocol? MSTP STP RSTP PAgP Which settings must match on both sides of the switch ports to form an EtherChannel? vlans & SNMP strings should match Interface speed, duplex & vlan should match Only the Switch numbers must match Only the switch port numbers must match A trunk link between two switches has reached its capacity. How can this be addressed in the most economical way? Decrease the size of inter-switch collision domain by configuring additional VLANs Create additional broadcast domains by inserting a router between the switches Combine physical ports into a high-speed logical link by configuring the EtherChannel Increase the speed of the ports What is a best practice to use before beginning an EtherChannel implementation? Shut down each of the affected interfaces Enable each of the affected interfaces Assign affected interfaces to an unused VLAN Assign affected interfaces to VLAN 1 Which ones are valid load balancing methods of EtherChannel technology? Source Router, Destination Router Source computer, Destination computer Middle IP, Destination IP, Source MAC Source IP, Destination IP, Source MAC Which EtherChannel mode has been used in this configuration? Un-defined ON PAgP LACP Which statement describes a characteristic of EtherChannel? It can bundle mixed types of 100 Mbps and 1 Gbps Ethernet links It is made by combining multiple physical links that are seen as one link between two switches It can bundle mixed types of 10 Mbps and 100 Mbps Ethernet links It can combine up to a maximum of 4 physical links Which one of below is an advantage of using EtherChannel technology? EtherChannel supports fiber links A spanning tree recalculation is not required when a single link within the channel goes down EtherChannel shutdowns the unused interfaces in the bundle to avoid loops Load balancing is not needed with EtherChannel Which Cisco command can be used to enter into EtherChannel interface configuration mode? #channel-group 1 #interface range 1 #interface port-channel 1 #interface 1 Loading … Written by
